Prelude Type-SH L4-2157cc 2.2L DOHC H22A4 (VTEC) 16V (1998)
7. Remove the 6 mm brake disc retaining screws:
CAUTION: Be careful not to damage the ball joint boot.
8. Screw two 8 x 12 mm bolts into the disc to push it away from the hub.
NOTE: Turn each bolt two turns at a time to prevent cocking the disc excessively.
9. Remove the wheel sensor from the knuckle.
NOTE: Do not disconnect the wheel sensor connector.
10. Clean any dirt or grease off the ball joint.
11. Remove the cotter pin from the ball joint castle nut, and remove the nut.
12. Install a 12 mm hex nut on the ball joint. Be sure that the 12 mm hex nut is flush with the ball joint pin end to prevent damage to the threaded end
of the ball joint.