Prelude Type-SH L4-2157cc 2.2L DOHC H22A4 (VTEC) 16V (1998)
NOTE: If necessary, apply penetrating type lubricant to loosen the ball joint.
27. Pull the knuckle outward, and remove the driveshaft outboard joint from the knuckle by tapping the driveshaft end with a plastic hammer, then
remove the knuckle.
NOTE: Replace the bearing with a new one after removal.
28. Separate the hub from the knuckle using the special tool and a hydraulic press.
CAUTION:
-
Take care not to distort the splash guard.
-
Hold onto the hub to keep it from falling when pressed clear.
29. Remove the circlip and the splash guard from the knuckle.