Prelude Type-SH L4-2157cc 2.2L DOHC H22A4 (VTEC) 16V (1998)
Clutch Release Bearing: Service and Repair
REMOVAL
1. Remove the release fork boot from the clutch housing.
2. Remove the release fork from the clutch housing by squeezing the release fork set spring with pliers. Remove the release bearing.
3. Check the release bearing for play by spinning it by hand.
CAUTION: The release bearing is packed with grease. Do not wash it in solvent. If there is excessive play, replace the release bearing with a new
one.
INSTALLATION
NOTE: Use Super High Temp Urea Grease (P/N 087989002).
1. Install the release fork set spring on the release fork.