Prelude Type-SH L4-2157cc 2.2L DOHC H22A4 (VTEC) 16V (1998)
Fluid Pressure Sensor/Switch: Service and Repair
1. Disconnect the connector from the 2nd clutch pressure switch.
2. Replace the 2nd clutch pressure switch, then install a new one with a new sealing washer.
3. Tighten the 2nd clutch pressure switch on the metal part of the switch.
CAUTION:
-
Do not tighten the plastic part of the 2nd clutch pressure switch; it may damage the switch.
-
Do not allow water, fluid, oil, dust, or other foreign particles get inside the connector.