Ridgeline V6-3.5L (2006)
10. Disconnect the drain tube (A), and remove the clips, then remove the drain tube joint (B).
11. To remove the rear drain valve (A), tie a string to the end of the drain tube (B), then pull the drain tube down through the C-pillar.
12. Install the frame and drain tube in the reverse order of removal, and note these items:
-
Before installing the frame, clear the drain tubes and drain valves using compressed air.
-
When installing a drain tube, tie the string that was pulling through the pillar during the disassembly to the top end of the new drain tube, pull it
up through the pillar to the moonroof frame.
-
Check the frame seal.
-
Clean the surface of the frame.
-
When installing the frame, first attach the rear hooks into the body holes.
-
Make sure the connectors are plugged in properly.
-
When connecting the drain tube, slide it over the frame nozzle at least 10 mm (0.39 in.).
-
Install the tube clip (A) on the drain tube (B) as shown.
-
Make sure the clips are not rubbing on any parts or body panels.
