Ridgeline V6-3.5L (2006)
Interior Lighting Module: Testing and Inspection
Control Unit Input Test
NOTE: Make sure the ignition switch is OFF before disconnecting the driver's under-dash fuse/relay box connectors.
1. Before testing the entry light control functions, troubleshoot the multiplex integrated control system using B-CAN System Diagnosis Test Mode A.
Multiplex Integrated Control Unit
2. Remove the left kick panel.
3. Disconnect the under-dash fuse/relay box connectors.
NOTE: All connector views are wire side of female terminals.
4. Inspect the connector terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 5.
5. With the driver's under-dash fuse/relay box connectors still disconnected, make these input tests at the appropriate connector.
-
If any test indicates a problem, find and correct the cause, the recheck the system.
-
If all the input tests prove OK, go to step 6.
