S2000 L4-1997cc 2.0L DOHC (VTEC) MFI (2001)
Trim Panel: Service and Repair
Trim Removal/Installation - Front Roof Area
Trim Removal/Installation - Front Roof Area
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
NOTE:
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Take care not to bend or scratch the trim and panels.
1. Remove the trim in the numbered sequence.
2. Install the trim in the reverse order of removal, and note these items:
-
Check for damaged or stress-whitened clips, and replace them with new ones.
-
Make sure the connector is plugged in properly.
-
Push the clips into place securely.
-
If the threads on the visor screws are worn out, use an oversized screw (P/N 90132-SZ3-003) made specifically for this application.