S2000 L4-1997cc 2.0L DOHC (VTEC) MFI (2001)
Air Bag(s) Arming and Disarming: Service Precautions
SRS Unit Precautions
SRS Unit Precautions
-
Be careful not to bump or impact the SRS unit whenever the ignition switch is ON (II), or for at least for 3 minutes after the ignition switch is
turned OFF.
-
During installation or replacement, be careful not to bump (by impact wrench, hammer, etc.) the area around the SRS unit. The airbags could
accidentally deploy and cause damage or injury.
-
After a collision in which the airbags were deployed, replace the SRS unit and other related components. After a collision in which the airbags
were not deployed, inspect for any damage or any deformation on the SRS unit. If there is any damage, replace the SRS unit.
-
Do not disassemble the SRS unit.
-
Turn the ignition switch OFF, disconnect the battery negative cable, and wait at least 3 minutes before beginning installation or replacement of the
SRS unit, or disconnecting the 18P connector.
-
Be sure the SRS unit is installed securely with the mounting bolts torqued to 9.8 N.m (1.0 kgf.m, 7.2 lbf.ft).
-
Do not spill water or oil on the SRS unit, and keep it away from dust.
-
Store the SRS unit in a cool (less than 104°F/40°C) and dry (less than 80% relative humidity, no moisture) area.