S2000 L4-1997cc 2.0L DOHC (VTEC) MFI (2001)
8. Screw two 8 x 1.25 mm bolts (B) into the disc to push it away from the hub. Turn each bolt two turns at a time to prevent cocking the disc
excessively.
9. Remove the brake disc from the knuckle.
10. Check the hub for damage and cracks.
11. Remove the cotter pin (A) from the tie-rod end ball joint, then remove the nut (B).
12. Remove the tie-rod ball joint from the knuckle using the special tool.
13. Remove the cotter pin (A) from the lower arm ball joint, and remove the castle nut (B).
14. Remove the lower arm ball joint from the knuckle using the special tool.
15. Remove the clip (A) from the upper arm ball joint, and remove the castle nut (B).
16. Remove the upper arm ball joint from the knuckle using the special tool.
17. Remove the knuckle.