S2000 L4-1997cc 2.0L DOHC (VTEC) MFI (2001)
_mfi/Page-1655003.png)
-
If the airbags deploy and the green light on the tool comes on, continue with this procedure.
-
If an airbag doesn't deploy, yet the green light comes ON, its igniter is defective. Go to Disposal of Damaged Components
-
During deployment, the airbags, can become hot enough to burn you. Wait 30 minutes after deployment before touching the airbags.
11. Dispose of the complete airbag. No part of it can be reused. Place it in a sturdy plastic bag (A) and seal it securely.
Deploying the Airbags/Tensioner (Outside Vehicle)
Airbag Disposal
Special Tool Required
Deployment Tool 07HAZ-SG00500
Before scrapping any airbags (including those in a whole vehicle to be scrapped), the airbags must be deployed. If the vehicle is still within the warranty
period, the Honda District Service Manager must give approval and/or special instructions before deploying the airbags (and seat belt tensioners). Only
after the airbags (and seat belt tensioners) have been deployed (as the result of vehicle collision, for example), can they be scrapped. If the airbags (and
seat belt tensioners) appear intact (not deployed), treat them with extreme caution. Follow this procedure.
Deploying Components Out of the Vehicle
If an intact airbag or seat belt tensioner has been removed from a scrapped vehicle, or has been found defective or damaged during transit, storage, or
service, it should be deployed as follows:
1. Confirm that the special tool is functioning properly by following the check procedure or on the tool label.
2. Position the airbag face up, outdoors on flat ground at least 30 feet (10 meters) from any obstacles or people.
3. Follow steps 8 through 11 of the in-vehicle deployment procedure.
Deployment Tool Check Procedure
Deployment Tool Check
1. Connect the yellow clips to both switch protector handles on the tool; connect the tool to a battery.
2. Push the operation switch: green means the tool is OK; red means the tool is faulty.
3. Disconnect the battery and the yellow clips.
Disposal of Damaged Components
