S2000 L4-2.2L (2004)
3. Install the outer handle in the reverse order of removal, and note these items:
-
Make sure the cylinder switch harness is routed properly.
-
Make sure the cylinder switch connector is plugged in properly, and the rods are connected securely.
-
When installing the lock cylinder, leave the outer handle bolts loose so the outer handle protector does not interfere with the lock cylinder
installation, then tighten the handle bolts.
-
Install the retainer clip on the outer handle, then install the lock cylinder. Be sure the retainer clip is fully seated in the slot on the lock cylinder.
-
Make sure the door locks and opens properly.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its perimeter.