S2000 L4-2.2L (2004)
Use the double action sander and #320-#400-#600 disc papers.
5. Air blowing / degreasing
Use alcohol, wax, and grease remover.
Also clean and degrease surfaces where the masking tape will be attached.
Intermediate Coating
Intermediate Coating
1. Masking
Mask the area surrounding the damage to prevent over spray from the intermediate coat.
Use masking tape and paper.
2. Spraying top coat enamel
Spray the top coat enamel over the surface until the primer surface is fully covered.
-
Use the 2-part polyester urethane top coat enamel and spray gun.
-
Mix the top coat enamel with the additive and solvent, and in the correct ratio.
-
Follow the top coat manufacturer's instructions.
3. Drying
After spraying top coat enamel, allow for 5-10 minutes of normal drying time, then force dry it with infrared lamps or other industrial dryer.
NOTE: Follow the top coat manufacturer's instruction for drying time.
