S2000 L4-2.2L (2004)
4. Polishing
Check that the top coat enamel has dried thoroughly, then sand the top coat enamel.
Use the double action sander and #600-#800 disc papers.
NOTE: Be careful not to polish down to the primer surfacer.
When the painting repair is almost done, polish the area to top coat.
Use the #2000 sandpaper and compound.
5. Air blowing / degreasing
Use alcohol, wax, and grease remover.
Also clean and degrease surfaces where the masking tape will be attached.
Top Coating
Top Coating
1. Masking
Mask the area surrounding the damage to prevent over spray from the top coat.
Use masking tape and paper.
2. Spraying top coat enamel / clear coat
Spray 2-3 double coat until the intermediate coat is fully covered.
-
Use the 2-part polyester urethane top coat enamel and spray gun.
-
Mix the top coat enamel with the additive and solvent, and in the correct ratio.
-
Follow the top coat manufacturer's instructions.
Drying
After spraying the top coat enamel, allow it to dry, then force dry it with infrared lamps or other industrial dryer.
NOTE: Follow the top coat manufacturer's instructions for drying time.
Spraying clear coat
