S2000 L4-2.2L (2004)
2. Spraying top coat enamel / clear coat
Spray 2-3 coats in double coat until the intermediate coat is fully covered.
NOTE:
-
Do not cover the surface with one heavy coat.
-
Apply several thin coats.
-
Use the 2-part polyester urethane top coat enamel and spray gun.
-
Mix the top coat enamel with the additive and solvent, using the correct ratio.
-
Follow the top coat manufacturer's instructions.
After spraying the top coat enamel, allow for 5-10 minutes drying time before you spray the clear coat.
Drying
NOTE: Take care not to let the heat lamp deform the bumper during the drying process.
After spraying clear coat, allow for 5-10 minutes drying time before you force dry it with infrared lamps or other industrial dryer.
3. Polishing / buffing
-
Check that the clear coat has dried thoroughly.
-
Wet sand to remove any imperfections.
Use a flexible block, soap and #2000 sandpaper.
-
Using a buffer and compound, remove any polishing marks made from the sandpaper.
Use a buffing sponge, and buffing wool and compounds.
Finishes up with buffing:
-1. Wet sands with #2000 sandpaper and soapy water.
-2. Remove moisture using compressed air.
-3. Finish using fine compound and very compound. Do not polish with a electric polisher.
NOTE: Polish lightly.
-4. Check the finished area at an angle and make sure there are no polishing marks.
