S2000 L4-2.2L (2004)
-
If an airbag doesn't deploy, yet the green light comes ON, its igniter is defective. Go to Disposal of Damaged Components.
-
During deployment, the airbags, can become hot enough to burn you. Wait 30 minutes after deployment before touching the airbags.
11. Dispose of the complete airbag. No part of it can be reused. Place it in a sturdy plastic bag (A) and seal it securely.
Deploying Components Out of the Vehicle
If an intact airbag or seat belt tensioner has been removed from a scrapped vehicle, or has been found defective or damaged during transit, storage, or
service, it should be deployed as follows:
1. Confirm that the special tool is functioning properly by following the check procedure or on the tool label.
2. Position the airbag face up, outdoors on flat ground at least 30 feet (10 meters) from any obstacles or people.
3. Follow steps 8 through 11 of the in-vehicle deployment procedure.
Disposal of Damaged Components
1. If installed in the vehicle, follow the removal procedure for the driver's airbag, passenger's airbag, and seat belt tensioner.
2. In all cases, make a short circuit by cutting, stripping, and twisting together the two airbag inflator wires and seat belt tensioner wires.
3. Package the airbag or seat belt tensioner in the same packaging that the new replacement part came in.
4. Mark the outside of the box "DAMAGED AIRBAG NOT DEPLOYED" or "DAMAGED SEAT BELT TENSIONER NOT DEPLOYED" so it
does not get confused with your parts stock.
5. Contact your Honda District Service Manager for how and where to return it for disposal.
Deployment Tool Check
1. Connect the yellow clips to both switch protector handles on the tool; connect the tool to a battery.
2. Push the operation switch: green means the tool is OK; red means the tool is faulty.
3. Disconnect the battery and the yellow clips.
