H2 V8-6.0L (2004)
Body Control Module: Service and Repair
Body Control Module (BCM) Programming/RPO Configuration
BODY CONTROL MODULE (BCM) PROGRAMMING/RPO CONFIGURATION
INTRODUCTION
The procedures below are designed to set-up the body control module (BCM) correctly during BCM related service. Before you start, read these
procedures carefully and completely.
IMPORTANT: The following procedures must be followed:
1. Programming the BCM
2. Programming Theft Deterrent System Components
PROGRAMMING THE BCM
IMPORTANT: After the procedure is completed, the personalization settings of the BCM are set to a default setting. Inform the customer that the
personalization must be set again.
Perform the BCM special function "Request BCM Info. for SPS", then connect the scan tool to SPS terminal. Refer to Service Programming System
(SPS) in Programming.
PROGRAMMING THEFT DETERRENT SYSTEM COMPONENTS
Perform the Programming Theft Deterrent System Components in Theft Deterrent after successfully finishing the Setup New BCM procedure. If the
Programming Theft Deterrent System Components in the Theft Deterrent procedure is not performed after a BCM replacement, one of the following
conditions will occur:
-
The vehicle will not be protected against theft by the PASSLOCK system.
-
The engine will not crank nor start.
IMPORTANT: After programming, perform the following to avoid future misdiagnosis:
1. Turn the ignition OFF for 10 seconds.
2. Connect the scan tool to the data link connector.
3. Turn the ignition ON with the engine OFF.
4. Use the scan tool in order to retrieve history DTCs from all modules.
5. Clear all history DTCs.
