H2 V8-6.0L (2004)
Air Bag Control Module: Technical Service Bulletins
Restraint System - Proper Air Bag System Diagnosis
Bulletin No.: 03-09-41-003
Date: July 29, 2003
INFORMATION
Subject:
Proper Air Bag System Diagnosis and Service
Models:
2004 and Prior Passenger Cars and Light Duty Trucks
This bulletin is being issued to emphasize several aspects of proper diagnosis and servicing of the Air Bag System.
Air Bag Readiness Light
As stated in Owners Manuals, if the air bag readiness light stays on after the vehicle is started, the system may not be working properly. The air bags may
not inflate in a crash or may even inflate without a crash. If the Air Bag Readiness Light/Indicator is illuminated or comes on intermittently, diagnose to
determine the cause. Refer to Air Bag Indicator Circuit Malfunction in the SIR sub-section of the appropriate Service Manual.
Replacement of Soaked SDMs
As stated in Service Manuals, if the vehicle interior is exposed to moisture and becomes soaked up to the level of the sensing and diagnostic module
(SDM), the SDM and SDM harness connector must be replaced. The SDM could be activated when powered, which could cause air bag deployment and
result in personal injury. The air bags, as well as the sensors and related parts, would have to be replaced. To help avoid this situation, turn the ignition
off immediately. DO NOT turn the ignition back on, even to tow the vehicle, unless the battery cable is first disconnected.
Replacement of SDM that Shows Signs of Water Exposure or Corrosion
If an SDM that is being replaced shows signs of water exposure or corrosion and the customer does not know the source of the water exposure, then the
vehicle should be checked for water leaks. If leaks are found, the customer should be advised to have them repaired to help avoid damage to the
replacement SDM.
Disclaimer
