H2 V8-6.0L (2004)
3. Install the rear air spring compressor mounting nuts and bolts.
Tighten
Tighten the bolts to 50 N.m (37 lb ft).
4. Install the front air spring compressor mounting bolts.
Tighten
Tighten the bolts to 50 N.m (37 lb ft).
5. Connect the air spring compressor electrical connector.
6. Connect the ground strap.
Tighten
Tighten bolt to 6 N.m (53 lb in).
7. Connect the air inflator switch electrical connector.
8. Remove the support from the compressor
9. Lower the vehicle.
10. Start the vehicle and run for approximately 2 minutes to ensure that the air spring leveling system is functioning properly.
11. Verity the D height.
12. Check for leaks. If a leak is found at the air supply line connections replace the air supply lines.
