H2 V8-6.0L (2004)
Shift Solenoid: Service and Repair
CONTROL AND SHIFT SOLENOIDS REPLACEMENT
REMOVAL PROCEDURE
1. Remove the transmission oil pan and filter.
IMPORTANT: Do not remove the valve body for the following procedures. Removal of the 1-2 accumulator is necessary only if servicing the
pressure control solenoid.
2. Remove the 1-2 accumulator if necessary.
3. Disconnect the internal wiring harness electrical connectors from the following components:
-
Transmission fluid pressure switch (1)
-
1-2 shift control solenoid (2)
-
2-3 shift control solenoid (3)
-
Pressure control solenoid (4)
-
TCC PWM solenoid (5)
-
3-2 control solenoid (6)
4. Remove the pressure control solenoid retainer.
5. Remove the pressure control solenoid.