H2 V8-6.2L (2008)
8.
Remove the white dress cover from the connector.
9.
Refer to the EBCM Wiring Schematic to locate the correct connector cavities and terminal wire colors for the cross-wired wheel speed sensors.
Note:
Wires into cavities 6 and 37 may be switched (front wheels) or wires into cavities 4 and 35 may be switched (rear wheels).
10.
Remove one of the cross-wired terminal wires from its connector cavity and install this terminal wire in the correct location of the connector. Do
likewise with the other cross-wired terminal wire. The two wires should now be located in each other's original pin locations in the connector.
11.
Connect the wheel speed sensors and clear the DTCs. Ensure that there are no DTCs set.
