H2 V8-6.2L (2008)
Wheel Speed Sensor: Service and Repair
Front Wheel Speed Sensor Replacement
Front Wheel Speed Sensor Replacement
Caution: Refer to Brake Dust Caution (See: Service Precautions/Technician Safety Information/Brake Dust Caution) .
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance) .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair) .
3. Remove the brake rotor. Refer to Front Brake Rotor Replacement (See: Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Front Brake Rotor Replacement) .
4. Remove the WSS cable mounting clip from the knuckle.
5. Remove the WSS cable mounting clip from the upper control arm.
6. Remove the WSS cable mounting clip from the frame attachment point.
7. Disconnect the WSS cable electrical connector.
8. Remove the wheel speed sensor (WSS) mounting bolt.
NOTICE: Carefully remove the sensor by pulling it straight out of the bore. DO NOT use a screwdriver, or other device to pry the sensor out of
the bore. Prying will cause the sensor body to break off in the bore.
9. Remove the wheel speed sensor (5) from the hub/bearing assembly (4).
Installation Procedure
