H2 V8-6.2L (2008)
3.
Disconnect the left front and left rear wheel speed sensor wires. The front wheel speed sensor wire can be disconnected at the connection near the
upper control arm pivot point on the frame (1). The left rear wheel speed sensor wire can be disconnected at the wheel speed sensor on the end of
the axle housing near the wheel (2).
4.
Using the Tech 2(R) determine if the DTC set corresponds to the wheel speed sensor that was disconnected.
^
If the DTC set corresponds to the sensor disconnected, proceed to Step 11.
^
If the DTC set does NOT correspond to the sensor disconnected, then the left and right wheel speed sensor wires are cross-wired. Lower the
vehicle. Refer to the EBCM Wiring Schematic and Step 5.
