H2 V8-6.2L (2008)
Important: Use a small flat-bladed tool and lift the inner edge of the caliper boots next to both pistons to release any trapped air.
2. Ensure that the caliper boots are below the level of the face of both pistons.
3. Install the brake caliper to the brake caliper mounting bracket.
4. Perform the following procedure before installing the caliper guide pin bolts.
1. Remove all traces of the original adhesive patch.
2. Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry.
3. Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
5. Install the brake caliper mounting bolts.
Notice: Refer to Fastener Notice .
6. Tighten the brake caliper guide pin bolts.
Tighten the brake caliper guide pin bolts to 108 N.m (80 lb ft).
7. Remove the rubber cap or plug from the exposed brake hose fitting end.
Important: Install 2 new copper brake hose gaskets.
8. Assemble the 2 new copper brake hose gaskets and the brake hose to caliper bolt to the brake hose.
