H2 V8-6.2L (2008)
Brake Pad: Service and Repair
Front Disc Brake Pads Replacement
Front Disc Brake Pads Replacement
Caution: Refer to Brake Dust Caution (See: Service Precautions/Technician Safety Information/Brake Dust Caution) .
Removal Procedure
1. Inspect the fluid level in the brake master cylinder reservoir.
2. If the brake fluid level is midway between the maximum-full point and the minimum allowable level, no brake fluid needs to be removed from the
reservoir before proceeding.
3. If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, remove brake fluid to the
midway point before proceeding.
4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance) .
5. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair)
.
6. Inspect the caliper operation. Refer to Brake Caliper Inspection (See: Brake Caliper/Testing and Inspection) .
Notice: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible
brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which
may cause damage to the brake hose and in turn may cause a brake fluid leak.
7. Remove the caliper mounting bolts and remove the caliper from the mounting bracket. Support the caliper with heavy mechanic's wire or
equivalent. DO NOT disconnect the hydraulic brake flexible hose from the caliper.
8. Remove the brake pads from the caliper mounting bracket.
