H2 V8-6.2L (2008)
Wheel Speed Sensor: Service and Repair
Rear Wheel Speed Sensor Replacement
Rear Wheel Speed Sensor Replacement
Caution: Refer to Brake Dust Caution (See: Service Precautions/Technician Safety Information/Brake Dust Caution) .
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance) .
2. Disconnect the electrical connector.
3. Remove the wheel speed sensor retaining bolt.
Important: If a shim was removed when the wheel speed sensor was removed, it must be reinstalled to ensure proper operation.
4. Remove the wheel speed sensor and shim if present.
Installation Procedure
Important: If a shim was removed when the wheel speed sensor was removed, it must be reinstalled to ensure proper operation.
1. Install the shim, if removed with the sensor, and the wheel speed sensor.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the wheel speed sensor retaining bolt.
Tighten the bolt to 14 N.m (124 lb in).
