H2 V8-6.2L (2008)
9. Place the cord into position.
Notice: The heater cord must not touch the engine, hot pipes, manifold, or any moving parts. Route the cord to the left front of the engine
compartment securing with tie straps as necessary to prevent damage.
10. Install the heater cord bolt and retainer.
Tighten the heater cord bolt to 8 N.m (71 lb in).
11. Position the oil cooler hose adapter.
12. Install a NEW oil cooler hose adapter gasket.
13. Install the oil cooler hose adapter bolts (2).
Tighten the oil cooler hose adapter bolts to 12 N.m (106 lb in).
14. Install the oil cooler hose bracket bolt (1).
Tighten the oil cooler hose bracket bolt to 25 N.m (18 lb ft).
15. Lower the vehicle.
16. Fill the cooling system/engine block. Refer to Cooling System Draining and Filling (Static Fill) (See: Cooling System/Service and
Repair/Draining and Filling Cooling System)Cooling System Draining and Filling (Vac-N-Fill) (See: Cooling System/Service and
Repair/Draining and Filling Cooling System) .
