H2 V8-6.2L (2008)
4. Raise the rear axle, using the adjustable jackstands.
5. Install the lower bolts and nuts to the rear shock absorbers.
Tighten the bolts to 95 N.m (70 lb ft).
6. Remove the adjustable jack stands from under the rear axle.
7. Install the vent hose swivel clip to the rear brake crossover pipe.
8. Install the rear axle vent hose to the rear axle, if necessary.
9. If vehicle is equipped with RPO Z55, install the left and right sensor link rods to the sensors.
10. Using J 38185 install the link rods to the ball studs on the sensor levers.
11. If vehicle is equipped with RPO Z55, connect the following left side chassis harness electrical connectors:
