H2 V8-6.2L (2008)
2. Disconnect the electrical connection from the recirculation actuator (1).
3. Remove the recirculation actuator retaining screws.
4. Remove the recirculation actuator.
Installation Procedure
1. Install the recirculation actuator.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the recirculation actuator retaining screws.
Tighten the screws to 1.6 N.m (14 lb in).
3. Connect the electrical connector to the recirculation actuator (1).
4. Install the air distribution duct. Refer to Air Distributor Duct Replacement (See: Air Duct/Service and Repair/Air Distributor Duct Replacement) .
5. Re-calibrate the recirculation actuator. Refer to Actuator Recalibration (See: Testing and Inspection/Programming and Relearning/Actuator
Recalibration) .
Mode Actuator Replacement
Mode Actuator Replacement
