H2 V8-6.2L (2008)
Hose/Line HVAC: All Technical Service Bulletins
Interior - Rattle From Right Side of Instrument Panel
Bulletin No.: 08-01-39-002
Date: January 18, 2008
TECHNICAL
Subject:
Rattle From Right Side Of Instrument Panel Typically Over Bumps (Reposition A/C Compressor Discharge Line)
Models:
2007-2008 HUMMER H2
Condition
Some customers may comment on a rattle from the right side of the Instrument Panel (IP). The noise typically occurs when going over bumps.
Cause
This condition may be caused by the discharge line from the Air Conditioning (A/C) compressor to the condenser touching or close to the front lower
inboard corner of the right wheel house panel near the radiator. When going over bumps the A/C line may touch the wheelhouse panel and cause a rattle.
Correction
Technicians are to reposition the A/C compressor discharge line as necessary to provide clearance at the right wheelhouse panel. Create a 13 mm (0.50
in) gap between the line and the wheelhouse panel. Do not move the line too far or it may touch the radiator vent hose and possibly restrict fluid flow.
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer
