H2 V8-6.2L (2008)
*
On vehicles not equipped with keyless entry, press and release the driver information center (DIC) INFO button until the RELEARN TIRE
POSITIONS message appears on the DIC display. Press and hold the SET/RESET button until a double horn chirp sounds and the DIC
displays a TIRE LEARNING ACTIVE message indicating the Learn Mode has been enabled. The left front turn signal will also be
illuminated.
3. Starting with the left front tire, learn the tire pressure using one of the following methods:
*
Hold the antenna of the J-46079 aimed upward against the tire sidewall close to the wheel rim at the valve stem location. Press and release the
activate button and wait for a horn chirp. Once the horn chirp has sounded, the turn signal in the next location to be learned will illuminate.
Caution: Over inflating tires may cause personal injury or damage to the tires and wheels. When increasing tire pressure do not exceed the
maximum inflation pressure as noted on the tire sidewall.
*
Increase/decrease the tire pressure for 8-10 seconds then wait for a horn chirp. The horn chirp may occur before or up to 30 seconds after the
8-10 second pressure increase/decrease time period has been reached. Once the horn chirp has sounded, the turn signal in the next location to
be learned will illuminate.
4. After the horn chirp has sounded and the right front turn signal is illuminated, repeat step 3 for the remaining 3 sensors in the following order:
1. Right front
2. Right rear
3. Left rear
5. After the LR sensor has been learned, a double horn chirp will sound indicating all sensors have been learned.
6. Turn OFF the ignition to exit the learn mode.
7. After the learn mode has been exited, adjust all tires to the recommended pressures. Refer to Vehicle Certification, Tire Placard, Anti-Theft, and
Service Parts ID Label (See: Application and ID/Vehicle Certification, Tire Placard, Anti-Theft, and Service Parts ID Label) .
