H2 V8-6.2L (2008)
9. Remove the ECM from the engine compartment.
Installation Procedure
1. Install the ECM to the ECM mounting bracket ensuring that the mounting tabs are engaged.
2. Secure the spring latch to the ECM.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
3. Connect the ECM connectors to the ECM.
Tighten the fasteners to 8 N.m (71 lb in).
4. Install the ECM cover to the ECM mounting bracket, ensuring the mounting tabs on the ECM mounting bracket are engaged into the mounting
holes in the ECM cover.
5. If a new ECM is being installed, program the ECM. Refer to Programming and Relearning (See: Testing and Inspection/Programming and
Relearning) .