H2 V8-6.2L (2008)
1. Use a screwdriver to rotate the ignition lock cylinder case gear clockwise to the start position - allowing it to spring return into the RUN position.
2. Install the key into the ignition lock cylinder.
3. Align the ignition lock cylinder and install it into the ignition lock cylinder case.
4. Install the steering column shroud. Refer to Steering Column Shroud Replacement (See: Steering and Suspension/Steering/Steering
Column/Service and Repair/Steering Column Shroud Replacement) .
5. Install the driver knee bolster. Refer to Driver Knee Bolster Replacement (See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Driver Knee Bolster Replacement) .
6. Enable the SIR system. Refer to SIR Disabling and Enabling (See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air
Bag(s) Arming and Disarming/Service and Repair) .
Ignition Lock Cylinder Case Replacement
Ignition Lock Cylinder Case Replacement
