H3 L5-3.7L (2007)
Drill the two new holes with a 6.5 mm (1/4 in) drill bit.
Apply GM Synthetic Lubrication with Teflon, P/N 12371287 (in Canada, 10953437) to the new drilled holes.
Tip
It is recommended to use an acid brush to apply this grease to the bare edges.
Install the license plate bracket and the two plastic push pin retainers.
Install the rear license plate and four screws.
Tighten the license plate screws.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer
