H3 L5-3.7L (2007)
1. Install a NEW camshaft cover seal into the camshaft cover groove.
2. Install NEW ignition control module seals into the camshaft cover grooves.
3. Position the camshaft cover to the cylinder head.
Notice: Refer to Fastener Notice.
4. Install the camshaft cover bolts.
Tighten the bolts to 10 N.m (89 lb in).
5. Install the fuel pressure regulator screw.
Tighten the screw to 8 N.m (71 lb in).
6. Connect the following electrical connectors to the camshaft cover:
^
The ECT sensor (1)
^
The fuel injector (2)
^
The HO2S (5)
7. Install the ignition coils.
8. Install the intake manifold.
