H3 L5-3.7L (2007)
Important: When reusing the sensor (1) you MUST install a pin into the sensor before it is removed from the steering shaft. By not
installing a pin into the sensor it will cause the sensor to lose its centering position and MUST be discarded.
Pin diameter must be in the range of 1.0-2.0 mm.
6. If reusing the sensor (1), remove the position sensor by pulling the sensor straight out from the bearing adapter (3) until the sensor is almost off the
steering shaft (2). Install a pin into the sensor before removing from the steering shaft (2). Do not remove the pin until the sensor is re-installed.
7. If replacing the sensor (1), remove the sensor by pulling the sensor straight out from the bearing adapter (3) and off the steering shaft.
8. Remove the bearing adapter (3).
Installation Procedure
Important: Do NOT apply force to the sensor (1) or the bearing adapter (3) in a sideways direction.
1. Install the bearing adapter (3) onto the steering shaft. The bearing adapter MUST be seated into the jacket assembly.
2. If reusing the sensor, with the pin still installed, align the sensor onto the steering shaft (2) and into the bearing adapter (3)
Important: If installing anew sensor the sensor will come precentered. Do NOT remove the pin until installation is complete.
3. Align the sensor onto the steering shaft (2) and into the bearing adapter (3)
4. Install the sensor connector.
5. Remove the pin from the sensor
6. Install the sensor retainer onto the steering shaft and into the bearing adapter.
