H3 L5-3.7L (2007)
6. Place an alignment mark between the pinion and the pinion yoke.
7. Install the J 8614-01 as shown.
8. Remove the pinion nut while holding the J 8614-01.
9. Remove the washer.
10. Install the J 8614-3 (2) and the J 8614-2 (3) into the J 8614-01 (1) as shown.
11. Remove the pinion yoke by turning the J 8614-3 (3) clockwise while holding the J 8614-01 (1).
Use a container in order to retrieve the lubricant.
12. Remove the pinion oil seal. Use a suitable seal removal tool. Do not damage the housing.
Installation Procedure
1. Using the J 33782, install the pinion seal.
2. Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the splines of the pinion yoke.
