H3 V8-5.3L (2008)
6. Remove the mounting bolts for the electronic brake and traction control module (1).
7. Remove the mounting bolt (6) for the fluid level sensor.
8. Remove the bracket (5) for the fluid level sensor wiring harness.
Important: When removing the electronic brake and traction control module from the brake master cylinder, ensure the locating pin
remains in the brake master cylinder body.
9. Remove the electronic brake and traction control module (2) from the brake master cylinder.
Important: DO NOT re-use the electronic brake and traction control module gasket.
10. Remove and discard the gasket (3) from the brake master cylinder.
Installation Procedure
1. Install a NEW electronic brake and traction control module gasket (3) to the master cylinder.
