H3 V8-5.3L (2008)
Crankshaft Position Sensor: Removal and Replacement
Crankshaft Position Sensor Replacement
Removal Procedure
1. Remove the starter. Refer to Starter Motor Replacement (LH8) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair
)Starter Motor Replacement (LLR) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair) .
2. Disconnect the engine wiring harness electrical connector (1) from the crankshaft position (CKP) sensor.
3. Clean the area around the CKP sensor before removal in order to avoid debris from entering the engine.
4. Remove the CKP sensor bolt.
5. Remove the CKP sensor.
Installation Procedure