H3 V8-5.3L (2008)
1. Install the ignition lock cylinder case.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install a new ignition lock cylinder case bolt and turn it until the head shears off.
3. Install the multifunction turn signal switch housing. Refer to Multifunction Turn Signal Switch Housing Replacement (See: Steering and
Suspension/Steering/Steering Column/Service and Repair/Multifunction Turn Signal Switch Housing Replacement) .
4. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement (See: Ignition Lock Cylinder Replacement) .
5. The Passlock sensor is part of the ignition switch. If replacing the switch, a theft deterrent relearn is needed. Refer to Control Module References (
See: Testing and Inspection/Programming and Relearning) .
6. Enable the SIR system. Refer to SIR Disabling and Enabling (See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air
Bag(s) Arming and Disarming/Service and Repair) .
