H3 V8-5.3L (2008)
1. Install the CKP sensor.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the CKP sensor bolt.
Tighten the bolt to 25 N.m (18 lb ft).
3. Connect the engine wiring harness electrical connector (1) to the CKP sensor.
4. Install the starter. Refer to Starter Motor Replacement (LH8) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair
)Starter Motor Replacement (LLR) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair) .
5. Perform the crankshaft position system variation learn procedure. Refer to Crankshaft Position System Variation Learn (See: Procedures) .
