H3 V8-5.3L (2008)
3. Remove the motor assembly (3).
4. Remove the nuts (1) and bracket (2) from the motor (3).
5. Retain the nuts and bracket to be transferred onto the replacement motor.
6. Remove the nuts and bracket from replacement motor, P/N 89059688, and transfer the original nuts and bracket to the replacement motor. DO
NOT TIGHTEN THE NUTS AT THIS TIME.
Important
A transfer case encoder motor D-ring seal, P/N 19209788 must be installed when replacing the motor. If the transfer case is of an earlier
design (including 2010 LH8 and 2011 LH9 NR4 service replacement assemblies, P/N 24243593 / 24247880), it may be necessary to remove
the motor to inspect and confirm the seal is present.
7. Install a new D-ring seal (12). If not originally equipped, add the seal during installation.
8. Install the motor (3) and bolts (1 and 2) to the transfer case.
Tighten
Tighten the BRACKET nuts to 10 Nm (89 lb in).
Tighten
Tighten the bolts to 10 Nm (89 lb in).
9. Install the connector (1) to the clip (2).
10. Reprogram the transfer case module using the Service Programming System (SPS) with the latest calibration available on TIS2WEB.
Parts Information
