H3 V8-5.3L (2008)
Correct Yaw Rate Sensor Location
Incorrect Yaw Rate Sensor Location
4.
Determine the orientation of the yaw rate sensor connector and wire harness.
^
If the connector and harness (2) are facing outward toward the location of the drivers side sill plate (3), repositioning of the yaw rate sensor is
required. The yaw rate sensor is installed 180 degrees out of position. Refer to Step 5.
^
If the connector and harness (2) are facing the console and passenger seat area (3), repositioning of the yaw rate sensor is not required. Refer to
Steps 10 and 12.
5.
Remove the driver's side front seat from the vehicle. Refer to Front Seat Replacement--Bucket in SI.
6.
Remove the front carpet enough to access the yaw rate sensor (1).
7.
Remove the two fasteners from the yaw rate sensor.
8.
Reposition the yaw rate sensor (1). The yaw rate sensor connector and harness (2) should face the console and passenger seat (3) area of vehicle.
Refer to Correct Yaw Rate Sensor Location illustration in this bulletin.
9.
Install the two fasteners.
Tighten
Tighten the fasteners to 9 Nm (80 lb-in).
10.
Reposition the carpet to its original location.
