H3 V8-5.3L (2008)
1. Install the accelerator pedal/APP sensor over the studs.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the accelerator pedal/APP sensor nuts.
Tighten the nuts to 9 N.m (80 lb in).
3. Connect the body wiring harness electrical connector to the APP sensor.
4. Inspect below the pedal for binding, to ensure full range of motion.
5. Install the knee bolster bracket. Refer to Driver Knee Bolster Bracket Replacement (Left Hand Drive) (See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair/Driver Knee Bolster Bracket Replacement (Left Hand Drive))Driver Knee Bolster Bracket
Replacement (Right Hand Drive) (See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Driver Knee
Bolster Bracket Replacement (Right Hand Drive)) .
