H3 V8-5.3L (2008)
Band Apply Servo: Service and Repair
2-4 Servo (3.7L)
2-4 Servo (3.7L)
Tools Required
J 29714-A Servo Cover Depressor
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair) .
2. Remove the front propeller shaft. Refer to Front Propeller Shaft Replacement (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair/Front Propeller Shaft Replacement) .
3. Clean away all dirt and debris from the 2-4 servo cover area.
4. Remove a single transmission oil pan bolt.
5. Install the J 29714-A in place of the transmission oil pan bolt.
6. Tighten the bolt in order to compress the servo cover.
7. Remove the servo cover retaining ring.
8. Remove the J 29714-A .
9. Remove the servo cover and the O-ring seal. If the cover is hung up on the seal, use a pick (2) to pull and stretch the seal (1) out of the groove. Cut
and remove the O-ring seal before removing the cover.
