H3 V8-5.3L (2008)
10. Remove the 2-4 servo from the transmission.
11. Inspect the 4th apply piston, 2-4 servo converter, 2nd apply piston, and the servo piston inner housing for the following defects.
*
Cracks
*
Scoring
*
Burrs and nicks
12. Disassemble the 2-4 servo if necessary. Refer to 2-4 Band Servo 2nd Apply Piston Disassemble (See: Service and Repair/Overhaul/Assemble,
Disassemble, and Installation/2-4 Band Servo 2nd Apply Piston Disassemble) .
13. Clean and inspect the 2-4 servo. Refer to 2-4 Band Servo Piston Pin Length Check (See: Service and Repair/Overhaul/Removal/2-4 Band Servo
Piston Pin Length Check) .
Installation Procedure
1. Assemble the 2-4 servo if previously disassembled. Refer to 2-4 Servo Assembly Installation (See: Service and Repair/Overhaul/Assemble,
Disassemble, and Installation/2-4 Servo Assembly Installation) .
2. Lightly lubricate the seals with clean transmission fluid.
3. Install new seals on the servo pistons and the servo cover.
4. Install the 2-4 servo assembly into the transmission.
5. Install the J 29714-A to the transmission oil pan flange.
6. Tighten the bolt in order to compress the servo cover.
7. Install the servo cover retaining ring.
8. Remove the J 29714-A .
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
