H3 V8-5.3L (2008)
10. Remove the servo cover retaining ring.
11. Remove the J 29714-A .
12. Remove the servo cover and the O-ring seal. If the cover is hung up on the seal, use a pick (2) to pull and stretch the seal (1) out of the groove. Cut
and remove the O-ring seal before removing the cover.
13. Remove the 2-4 servo from the transmission.
14. Inspect the 4th apply piston, 2-4 servo converter, 2nd apply piston, and the servo piston inner housing for the following defects.
*
Cracks
*
Scoring
*
Burrs and nicks
15. Disassemble the 2-4 servo if necessary. Refer to 2-4 Band Servo 2nd Apply Piston Disassemble (See: Service and Repair/Overhaul/Assemble,
Disassemble, and Installation/2-4 Band Servo 2nd Apply Piston Disassemble) .
16. Clean and inspect the 2-4 servo. Refer to 2-4 Band Servo Piston Pin Length Check (See: Service and Repair/Overhaul/Removal/2-4 Band Servo
Piston Pin Length Check) .
Installation Procedure
1. Assemble the 2-4 servo if previously disassembled. Refer to 2-4 Servo Assembly Installation (See: Service and Repair/Overhaul/Assemble,
Disassemble, and Installation/2-4 Servo Assembly Installation) .
2. Lightly lubricate the seals with clean transmission fluid.
3. Install new seals on the servo pistons and the servo cover.
