hummer Workshop Repair Guides

Hummer Workshop Service and Repair Manuals

Transmission Position Switch/Sensor, A/T|Service and Repair > < Transmission Position Switch/Sensor, A/T|Locations|Page 8525
Page 1
background image

Transmission Position Switch/Sensor: Adjustments

Park/Neutral Position and Backup Lamp Switch Adjustment

Important:  

*

The following procedure is for vehicles that have not had the switch removed or replaced. If the switch has been removed or replaced,
refer to Park/Neutral Position and Backup Lamp Switch Replacement (3.7L) 
 (See: Service and Repair/Park/Neutral Position and Backup
Lamp Switch Replacement (3.7L))Park/Neutral Position and Backup Lamp Switch Replacement (5.3L)  (See: Service and
Repair/Park/Neutral Position and Backup Lamp Switch Replacement (5.3L)) for the proper adjustment procedure.

*

Apply the parking brake.

*

The engine must start in the P (PARK) or N (NEUTRAL) positions only. 

*

Check the switch for proper operation. If adjustment is required, proceed as follows:

1. Place the transmission range selector in the N (NEUTRAL) position.
2. With an assistant in the drivers seat, raise and support the vehicle. Refer to Lifting and Jacking the Vehicle  (See: Maintenance/Vehicle

Lifting/Service and Repair) .

3. Loosen the park/neutral position switch mounting bolts.
4. With the vehicle in the N (NEUTRAL) position, rotate the switch while the assistant attempts to start the engine.
5. Following a successful start, turn the engine OFF.

Notice:  Refer to Fastener Notice  (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .

6. Tighten the bolts securing the park/neutral back up switch to the transmission.

Tighten the park/neutral back up switch bolts to 27 N.m (20 lb ft).

7. Lower the vehicle.
8. Check the switch for proper operation. The engine must start in the P (PARK) or N (NEUTRAL) positions only.
9. Replace the park/neutral position switch if proper operation can not be achieved. Refer to Park/Neutral Position and Backup Lamp Switch

Replacement (3.7L)  (See: Service and Repair/Park/Neutral Position and Backup Lamp Switch Replacement (3.7L))Park/Neutral Position and
Backup Lamp Switch Replacement (5.3L)  (See: Service and Repair/Park/Neutral Position and Backup Lamp Switch Replacement (5.3L)) .

Transmission Position Switch/Sensor, A/T|Service and Repair > < Transmission Position Switch/Sensor, A/T|Locations|Page 8525