H3 V8-5.3L (2008)
Repair/Overhaul/Disassembly/Shift Control Housing Disassemble) .
Installation Procedure
1. Assemble the control lever housing if previously disassembled. Refer to Shift Control Housing Assemble (See: Service and
Repair/Overhaul/Assembly/Shift Control Housing Assemble) .
2. Remove the masking from the control lever opening and ensure the sealing surface is clean and dry.
3. Place the control lever gasket (3) on to the transmission.
4. Position the control lever housing assembly (2) to the control lever assembly opening, aligning the bushing with the internal shift control lever.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
5. Install the control lever housing assembly bolts (1).
Tighten the bolts to 20 N.m (15 lb ft).
