Accent L4-1.6L (2003)
4. Press and hold the trained HomeLink button and observe the indicator light.
If the indicator light is solid/continuous, training is complete and your device should activate when the HomeLink button is pressed and released.
If the indicator light blinks rapidly for 2 seconds and then turns a solid/continuous light, proceed with the following training instructions for a rolling
code device. A second person may make the following steps quicker and easier. It is recommended that a ladder or similar device be used to obtain
access to the motor housing. Do not stand on the vehicle to perform the next steps.
5. At the garage door opener receiver (motor housing) in the garage, locate the "learn" or "smart" button (usually near the hanging antenna wire attached
to the unit). If there is difficulty locating the training button, refer to the garage door opener's manual.
6. Press and release the "learn" or "smart" button (the name and color of the button may vary by manufacturer).
NOTE: Once the button is pressed, there are 30 seconds in which to initiate the next step.
7. Return to the vehicle and firmly press and hold the trained HomeLink button for two seconds and release. Repeat the "press/hold/release" sequence up
to 3 times to complete the training process. If successful, your garage door should open or close during this step.
If the vehicle owner continues to have difficulty programming their HomeLink mirror, please have them contact HomeLink customer service directly at
1-800-355-3515 or www.homelink.com for further assistance.
PROCEDURE COMPLETE
