Accent L4-1.6L (2003)
Harness Inspection Procedures Part 2
SENSOR INSPECTION
1. Disconnect the crankshaft position sensor connector.
2. Measure the resistance between terminals 1 and 2.
Standard value: 0.486 - 0.594kOhm at 20 °C (68 °F)
3. If the resistance deviates greatly from the standard value, replace the sensor.
-
Standard value
Clearance between the crankshaft position sensor and crankshaft position sensor wheel: 0.5 - 1.5 mm (0.020 - 0.059 in)
-
Tightening torque
Crankshaft position sensor: 9 - 11 Nm (90 - 110 kg.cm, 7 - 8 lb.ft)